Billy Goat BC2403 Benutzerhandbuch

Seite von 36
 
 
 
Part No 500360 
F062210A 
BC2403 Series Brush Cutter Owner’s Manual
 
 
DO NOT run this equipment indoors or in any poorly ventilated area. Refueling outdoors 
is recommended. 
DO NOT refuel this equipment while the engine is running. Allow engine to cool for at 
least two minutes before refueling. 
DO NOT store gasoline near an open flame. 
DO NOT remove gas cap while engine is running. 
DO NOT start or operate engine if strong odor of gasoline is present. 
DO NOT start or operate engine if gasoline is spilled. Move equipment away from spill 
until gasoline has completely evaporated. 
DO NOT smoke while filling the fuel tank. 
DO NOT check for spark with spark plug or spark plug wire removed. Use an approved 
spark tester. 
DO NOT operate engine without a muffler. Inspect muffler periodically and replace if 
necessary. If equipped with muffler deflector, inspect deflector periodically and replace if 
necessary. 
DO NOT operate engine with grass, leaves or other combustible material near the 
muffler. 
DO NOT touch muffler, cylinder or cooling fins when hot. Contact with hot surfaces may 
cause severe burns. 
DO NOT leave equipment unattended while in operation. 
DO NOT park equipment on a steep grade or slope. 
DO NOT operate equipment with bystanders in or near the work area. 
DO NOT start equipment with drive or blade clutch engaged. 
DO NOT operate equipment with guards removed. 
DO NOT operate equipment in areas containing rock, glass, string-like material, wire, 
rags, cans, metal or other non-organic material. 
DO NOT operate equipment on slopes greater than specified in Specifications section of 
this manual. 
DO NOT operate  equipment near hot or burning debris or any toxic or explosive 
materials. 
DO NOT allow children to operate this equipment. 
ALWAYS  remove spark plug wire when servicing equipment to prevent accidental 
starting. 
ALWAYS  check fuel lines and fittings frequently for cracks or leaks. Replace if 
necessary. 
ALWAYS keep hands and feet away from moving or rotating parts. 
ALWAYS store fuel in approved safety containers.