Cub Cadet 24A-030E100 Benutzerhandbuch

7

Read this operator’s manual and safety rules before 
operating your chipper shredder vacuum. Compare the 
illustrations in Figure 5 with your unit to familiarize 
yourself with the location of various controls and 
adjustments. Save this manual for future reference.

The starter handle is attached to the right upper handle. 
Stand behind unit and pull the starter handle to start 
engine. See Figure 5.

Collects shredded material fed through the chipper 
chute or vacuumed through the nozzle. See Figure 5.

Used to grasp bag in order to assist in attaching, 
removing, and emptying bag. See Figure 5.

Allow twigs and small branches up to 1 1/2” in diameter 
to be fed into the impeller for chipping. See Figure 5.

When attached to unit the blower chute is used to blow 
or scatter yard waste such as leaves, pine needles, or 
small twigs across yard. See Figure 5.

Used to adjust the nozzle ground clearance ranging 
approximately 5/8” to 3 3/4”.

Yard waste such as leaves and pine needles can be 
vacuumed up through the nozzle for shredding.

The throttle control lever is located on the engine. It 
controls the engine’s speed and stops the engine. See 
separate engine manual packed with unit for details. 

See the separate engine manual for the location and 
function of the controls on the engine.

•

Move throttle control lever to STOP or OFF 
position.

•

Disconnect spark plug wire from spark plug and 
ground against the engine.