Tanaka TBL-505 Benutzerhandbuch

 

 

 
www.tanakapowerequipment.com                            4                                               custsvc@tanaka-ism.com 

 
 
 

 
 

 

 

 

 

• Use flexible pipe with wire clamps. 

• Install the pipe handle on swivel pipe or on straight pipe. Decide 

location and direction to your comfort. 

(Fig. 1-2) 

NOTE! (THB-2510, optional) 

Vacuum attachment is offered as an optional kit, which converts the hand-held blower into a vacuum cleaner. For installation, 

see THV-200 vacuum manual. 

Blow pipes to main body (Fig. 1-1) 
Inspect the main body and accessories, 
Connect straight pipe (1) and other pipe(s) 
securely. (See page 1) 
Align groove (2) in straight pipe with projection (3) on blower housing (or another pipe) and slide the pipe onto the blower 

housing (or another pipe). 
Rotate the pipe clockwise to lock it into place, then tighten the clamp band (if so equipped, THB-2510). 

NOTE! (TBL-4600, optional) 

• Connect flexible pipe (2) to main body with clamp (1). 

Finger-tighten the clamp. 

• Connect swivel pipe (4) to flexible pipe with clamp (3). 
• Install throttle grip (5) to swivel pipe so that the grip locates 2-3 cm away from projection (6) on swivel pipe. 
• Finally, if direction of bent pipe does not match the direction of throttle grip, loosen knob (7) or wing bolt (8) (enclosed in     

vinyl bag) and swivel the grip to your comfort. (Fig. 1 - 1 B)