Black & Decker LLP120 Benutzerhandbuch

TO InSTAll BATTERy PACK: Insert battery 

pack into tool until an audible click is heard  

(figure C).

TO REMOVE BATTERy PACK: Depress the 

battery release button in the back of the battery 

pack and pull battery pack out of tool.

 Read and understand all instructions. Failure to 

follow all instructions listed below may result in electric shock, fire 

and/or serious personal injury

before performing the following operations.  Failure to do this 

could result in serious personal injury. 

gloves when installing or removing the chain. The chain is sharp 

and can cut you when it is not running.

If the chain cannot be correctly tensioned, it may need to be 

replaced. Contact your nearest service center.

The product comes ready assembled. However we recommend that 

you check the tension of the chain, and chain retention bolts before 

use and if required adjust. 

To tension the chain slacken the 

two chain cover retention bolts 

(11) with the wrench (12) and the 

atuomatic chain tensioning device 

(fig E) will push the chain bar 

out, setting the correct tension. 

Retighten the two retention bolts 

(11) securely. 

Check that the correct tension has 

been set by lightly pulling on the 

chain. The tension is correct when 

the chain snaps back after being 

pulled 1/8 inch (3 mm) away from 

the guide bar. There should be no 

“sag” between the guide bar and 

chain on the underside.

Note:  Do not over tension the chain 

as this will lead to excessive wear 

and reduce the life of the bar and 

chain. It will also lead to reduced 

product performance.

Note:  With first use and when the chain is new, check tension 

frequently as a new chain stretches slightly.

After prolonged use the chain and / or chain bar may need 

replacing. Use Black & Decker replacement chain RC600 only.

Low-Kickback saw chain is a chain which has met the kickback 

performance requirements of ANSI B175.1 when tested on the 

representative sample of chain saws.

 laceration hazard. Always wear protective gloves 

when installing or removing the saw chain. The saw chain is sharp 

12

13 11