Snapper 2806 Merkblatt

INSTALLATION

INSTRUCTIONS

REAR

HITCH

MFG. NO. 1692010

INSTALLATION

Nate: Electric Lift Kit (1692032)

must be installed on

1714G tractors for all rear-mounted attachments.

Rear hitch required for mounting tiller to

Series tractors attachment.

1. Install the upper hitch assembly (A, figure 1) to the rear

tractor frame using four spacers (B), washers

and

1/2-13x 2

capscrews (D). Secure on inside of frame

with

nuts. The front capscrews are mounted

in the top frame holes and the

are

mounted in the bottom frame holes as shown in figure

2. Install the lower hitch assembly

to the tractor

using two

capscrews (G) and two i/2-

Secure the lower hitch brace to the rear frame using two

6-18

capscrews (H) and two

6 locknuts.

3. After the electric lift is installed, the lift rod (A, figure 2) will

be installed to the upper hitch as shown in figure and to
the lift arm assembly using a

pin (B) and safety clip

(C) as shown in figure 2.

Note: If tire chains are to be used for tiller operation, rear
wheels should be inverted for additional clearance between

RH wheel/chain and tiller lift rod.

FIGURE 2. Electric Lift
A. Lift Rod

Pin

FIGURE 1. Rear Hitch

A. Upper Hitch Assembly

Spacers

C. Washers
D. Capscrews,

x 2

E. Lower

Assembly

F.
G. Capscrews,

H. Capscrews,

C. Safety Clip

Form 1707679
Printed in USA