Snapper Z-rider Benutzerhandbuch

 

 

 
INTRODUCTION: These instructions cover the set-up of the Snapper Mid Mount Z-Rider Mower. Complete each 
of the following steps carefully. Review and complete each item as instructed on the Pre-Operation checklist. 
The Snapper Product Registration card must be filled out and sent to Customer Service department at Snapper 
when completed. 
 
IMPORTANT: The battery for this unit is shipped dry. A package of battery acid (electrolyte) will have to be 
purchased separately. Allow sufficient time for charging and installing the battery before operating the rider.  
Pay close attention to the precautionary statements on the battery and in these instructions. You will also need 
an automotive type battery charger to activate the battery for use. 
 
STEP 1: Remove machine from the container. The 
battery will have to be charged and installed. 
STEP 2:  Remove battery from the battery compartment 
before charging. 
STEP 3: Place battery in a well ventilated area on a 
level non-concrete surface. 
 

WARNING 

 
STEP 4: Remove battery cell caps. Fill cells as required 
with electrolyte (purchased separately) to proper level. 
Filling battery with electrolyte will bring the battery to 
80% charged state. 
 
 
 

 
 
 
STEP 5: With cell caps removed, connect battery 
charger to battery terminals; RED to positive (+) and 
BLACK to negative (-) terminal. 
STEP 6: Slow charge the battery at 2 amp for 2 hours 
to bring the battery to full charge. 
STEP 7: After charging, check level of electrolyte and 
add as needed to bring fluid to proper level. 
STEP 8: Reinstall cell caps. 
STEP 9: Install battery into power unit. 
 
 
 
 
 
 
 

STEP 10: Both bolts are already installed on both 
terminals. Connect positive (+) cable (red) first, from 
wiring harness to the positive terminal (+) on battery and 
secure with nut provided in hardware bag. Connect 
negative (-) cable (black) last, to negative terminal (-) on 
battery and secure with nut also provided. Apply a small 
amount of grease over terminals to prevent corrosion.  
See Figure 1. 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
STEP 11: Take the necessary precautions, when 
handling fuel. Fill the fuel tank with clean fuel. Check oil 
and add oil if needed as stated in Engine Owners 
Manual. Move fuel tank selector valve handle to the 
desired fuel tank.