Snapper LT Series Benutzerhandbuch

 

 
INTRODUCTION:  Snapper LT (One Piece Frame) Tractors are shipped with the steering wheel and seat 
cushions removed. The following steps are required for set-up. Complete all items on the Dealer Pre-Sale 
Checklist at time of purchase. 
 
NOTE:  Figure 1 shows the seat assembled to the seat 

pedestal assembly.  Some models are shipped 
with the seat loose and will require installation. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 
The battery is not installed and is shipped dry. Allow 
sufficient time for charging and installing the battery 
before operating the tractor.  Pay close attention to the 
precautionary statements on the battery and in these 
instructions.  Electrolyte must be purchased separately 
from your local dealer or retailer.  You will also need an 
automotive type battery charger to activate the battery for 
use. 
 

  1. Remove the seat/pedestal assembly by removing 

the two seat knobs that secure it to rear fender.  See 
Figure 1.   

Note: The seat switch wires are still connected, so be 
careful. 
  2.  Move the seat/pedestal assembly forward and out of 

the way. 

 

  1.  Remove battery from carton. 
  2. Place battery in a well ventilated area on a level 

surface. 

 
INSTRUCTION No. 7-2348 (I.R. 6/13/02) 
 

 
  3.  Remove battery cell caps.  Fill cells as required with 

electrolyte (purchased separately) to proper level.  
Fill to 3/16” above cell plates.  Filling battery with 
electrolyte will bring the battery to 80% charged 
state. 

 
Note:  3/16” above cell plates is the recommended level.  

DO NOT place anything in battery other than 
specified electrolyte.