Snapper GP215512KWV Benutzerhandbuch

 

 

 
4.2  WHEEL DRIVE CONTROL ADJUSTMENT 

1. The wheel drive control is properly adjusted 
when there is 1/16” to 1/8” clearance between the 
inside of the spring hook and the inside of the 
clutch cable eye with the wheel drive control 
released. See Figure 4.4. 

 

 

 

2.  To adjust, unhook upper spring from cable eye 
and rotate spring in direction required to extend or 
shorten spring length. 
3.  Rehook upper spring to cable eye and check 
clearance. Repeat procedure if required. 

 
NOTE: The vinyl spring cover should be kept over the 
spring at all times except for adjustments. 
 
 
 
 

4. If the wheel drive control fails to return quickly to 
the “OFF” position when released, check for 
binding at the cable clips located on the side of the 
right handle.  The upper clip should be located 2” 
below the upper bolt; the lower clip should be 4” 
above the lower bolt. The cable should slide freely 
with the clips installed at these locations.  

 
4.3  DRIVEN DISC SERVICE 

If the mower does not propel itself properly, See 
Figure 4.5. Check for the following problems: 

 

 

 

1.  Grease on drive disc causing slippage. 
2.  Broken or disconnected drive spring. 
3.  Driven disc is out of adjustment. 
4. Driven disc rubber ring is worn – does not 
contact drive disc properly. 
5.  Worn Poly-V Belt or engine drive belt. 

 
NOTE: If any of the above (1 thru 5) are causing 
problems, service as follows: