Snapper 5900887 Benutzerhandbuch
14
www.SnapperPro.com
Figure 4. Checking Tire Pressure
Check Tire Pressures
Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note that these
pressures may differ slightly from the “Max Inflation”
stamped on the side-wall of the tires. The pressures shown
provide proper traction, improve cut quality, and extend tire
life.
maintained at the levels shown in the chart. Note that these
pressures may differ slightly from the “Max Inflation”
stamped on the side-wall of the tires. The pressures shown
provide proper traction, improve cut quality, and extend tire
life.
Stopping the Mower
1. Gently squeeze both reverse speed control levers evenly
to stop the unit.
2. Once the unit is stopped, firmly depress the neutral
return pedal to place the transmission in neutral.
3. Disengage the PTO by pushing down on the PTO switch.
4. Engage the parking brake by pulling the handle up until
it locks into position.
5. Move the throttle control to mid-throttle position and
turn the ignition key to OFF. Remove the key.
Operation
Starting the Engine (Electric Start
Engines)
Engines)
1. Engage the parking brake and make sure that the
PTO switch is disengaged and the forward speed control
lever is in the NEUTRAL position.
lever is in the NEUTRAL position.
2. NOTE: A warm engine may not require choking.
Set the engine throttle control to FULL throttle position.
Then fully close the choke by pulling the knob OUT fully.
3. Insert the key into the ignition switch and turn it to
START.
4. After the engine starts, gradually open the choke (push
knob down fully). Reduce to half throttle speed and
allow to warm up.
allow to warm up.
Warm up the engine by running it for at least a minute
before engaging the PTO switch or driving the unit.
before engaging the PTO switch or driving the unit.
5. After warming the engine, ALWAYS operate the unit at
FULL THROTTLE when mowing.
In the event of an emergency the engine can be
stopped by simply turning the ignition switch to STOP.
Use this method only in emergency situations. For
normal engine shut down follow the procedure given in
STOPPING THE MOWER.
stopped by simply turning the ignition switch to STOP.
Use this method only in emergency situations. For
normal engine shut down follow the procedure given in
STOPPING THE MOWER.
Figure 5. Cutting Height Adjustment
A. Cutter Height Adjustment Handle
B. Cutting Height Indicator
A. Cutter Height Adjustment Handle
B. Cutting Height Indicator
A
Cutting Height Adjustment
S/N: 2014523388 & Above
The cutting height indicator (B, Figure 5) will help you
identify the cutting height.
identify the cutting height.
To Raise the Mower Deck:
Turn the cutting height adjustment handle (A, Figure 5)
clockwise.
clockwise.
To Lower the Mower Deck:
Turn the cutting height adjustment handle counter-clockwise.
B
Tire
Pressure
Front
N/A (Flat Free Tire)
Rear
15 psi
1.03 bar
Not
for
Reproduction