Snapper LT145H38GBV Benutzerhandbuch
27
Section 4 - ADJUSTMENT & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance or
service with the engine or blade running. STOP blade.
STOP engine. Set brake. Remove key. Remove spark
plug wire from spark plug and secure wire away from
spark plug. Engine and components can be extremely
hot. Avoid burns by allowing engine and components
sufficient time to cool.
service with the engine or blade running. STOP blade.
STOP engine. Set brake. Remove key. Remove spark
plug wire from spark plug and secure wire away from
spark plug. Engine and components can be extremely
hot. Avoid burns by allowing engine and components
sufficient time to cool.
4.4.7.
TRACTION DRIVE BELT REPLACEMENT
Mower Deck Removal
(Continued from previous page)
5. Remove hair pins from the front deck hanger
rod. See Figure 4.29.
rod. See Figure 4.29.
FIGURE 4.29
6. Hold front of deck "UP" and slide the front deck
hanger rod to the right and out then lower the front of
deck to the ground.
7. Remove hair pin and flat washer from rear deck
hanger bracket on both sides of tractor.
8. Make note of hole used in sector plates.
9. Slide sector plates off of rear deck hanger
brackets.
10. Slide deck forward.
Remove deck drive belt from engine pulley bottom
groove. See Figure 4.30.
hanger rod to the right and out then lower the front of
deck to the ground.
7. Remove hair pin and flat washer from rear deck
hanger bracket on both sides of tractor.
8. Make note of hole used in sector plates.
9. Slide sector plates off of rear deck hanger
brackets.
10. Slide deck forward.
Remove deck drive belt from engine pulley bottom
groove. See Figure 4.30.
FIGURE 4.30
11. Slide deck back and disconnect spring from
tension idler.
12. Pull deck from under tractor from R.H. side.
Traction drive belt removal
1. Remove two belt guide mounting bolts from each
side of tractor frame. See Figure 4.31.
tension idler.
12. Pull deck from under tractor from R.H. side.
Traction drive belt removal
1. Remove two belt guide mounting bolts from each
side of tractor frame. See Figure 4.31.
FIGURE 4.31
2. Slide belt guide assembly to the rear and remove.
3. Disconnect traction belt idler pulley spring from
tractor frame. See Figure 4.32.
3. Disconnect traction belt idler pulley spring from
tractor frame. See Figure 4.32.
FIGURE 4.32
RIGHT
SIDE
SHOWN
SIDE
SHOWN
FRONT
AXLE
AXLE
FRONT DECK
HANGER ROD
HANGER ROD
FRONT
LIFT ARM
LIFT ARM
HAIR PIN
ENGINE PULLEY
BOTTOM GROOVE
BOTTOM GROOVE
30” & 33” BELT GUIDES SHOWN
BELT GUIDE
MOUNTING
BOLTS (2 EACH
SIDE)
MOUNTING
BOLTS (2 EACH
SIDE)
BELT
GUIDE
GUIDE
RIGHT REAR
TRACTOR
FRAME
TRACTOR
FRAME
DISCONNECT
SPRING FROM
FRAME
SPRING FROM
FRAME