Snapper LT145H38GBV Benutzerhandbuch

 

Make the following checks and perform service as 
required before each start-up. 
2.1.1.  Check tires and add air as needed to bring 
pressure to 12 P.S.I. in front tires and 12 P.S.I. in 
rear tires.  
 
2.1.2. 

Check guards, deflectors and covers to make 

sure all are in place and securely tightened. If guards 
are missing or damaged, replace BEFORE using 
mower. 
 
2.1.3. 

Check engine oil and add oil as needed to 

bring level up to, but not over, the FULL mark.  Refer to 
engine owner’s manual for oil specifications. See Figure 
2.1.  
 

 

 
 

 
2.1.4.  Check blade engagement lever to insure it 
operates properly.  The blade engagement lever 
must be moved manually from “ON” to “OFF” to 
stop blade. 

Clean exterior surfaces of cutting deck, engine 

and tractor of any accumulation of dirt, grass, oil, etc.  
Keep engine air intake screens and cooling fins clean at 
all times. 
 
2.1.6. 

With engine “OFF” move the tractor outside 

and add fuel to the fuel tank. Securely tighten fuel cap 
after refueling. Refer to engine owner’s manual for fuel 
specifications. See Figure 2.2. 
 
2.1.7.  Check Reverse Lockout Mechanism. With 
engine “OFF”, raise blade engagement lever to "ON". 
The speed control lever cannot be shifted into 
“Reverse”. 
 
 
 
 
 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 

With the engine "OFF", raise operator's seat and 

loosen the two adjusting knobs on the seat support. 
Lower the seat. Sit in the operator's seat and slide the 
seat forward or backward until the clutch/brake pedal 
can be fully depressed comfortably. Raise seat and 
tighten the adjusting knobs to secure seat in position. 
See Figure 2.3.