Snapper LT180H48FBV2 Benutzerhandbuch

 

 

 
9.  Remove hair pin and flat washer from rear deck 
hanger bracket on both sides of tractor. 
10.  Make note of hole used in sector plates. 
11.  Slide sector plates off of rear deck hanger 
brackets. See Figure 4.22. 
12.  Slide deck from underneath machine. 
 
 

 

FIGURE 4.22 

 

13.  Disconnect traction belt idler pulley spring from 
tractor frame. See Figure 4.23. 
14.  Loosen mounting nuts on traction drive belt 
tension and stationary idlers just enough to allow belt 
to clear belt guides. See Figure 4.24. 
15. Remove traction drive belt from engine pulley top 
groove. Remove belt from transmission pulley. 
16.  Remove traction drive belt. 
 
Traction drive belt replacement 
1.  Place new traction drive belt over transmission 
pulley and span to engine pulley. 
2.  Place belt into top groove of engine pulley. 
3.  Route belt through stationary and tension idlers. 
See Figure 4.25. 
4.  Make certain belt is within belt guides of idlers. 
5.  Reattach tension idler spring to tractor frame.  

 

 
 
 
 

 

FIGURE 4.24 

 

 

NOTE:  When installing a new belt, make certain the 
stationary idler is mounted in the hole closest to the left 
hand side of the tractor.  
 

6.  Reinstall mower deck in reverse order of removal.