Snapper SPEL150KH Benutzerhandbuch

 

 

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
IMPORTANT: DO NOT jerk the engine recoil starter 
handle or allow it to snap back. 
 
NOTE: Engine will not start unless the transmission is in 
NEUTRAL position and Blade Clutch Switch is in OFF 
position. 
 
7.  Pull Engine Recoil Starter Handle.If the engine 

starts, move engine speed control back to the 
FAST position. If the engine made a firing sound 
but did not start, move engine speed control back to 
the FAST position and pull the engine recoil starter 
again and the engine should start. 

8. 

Depress Operator’s Presence Control (OPC) 

against handle. See Figure 3.5. 

9.  Place Transmission Shift Lever in No. 1 position 

(first gear).  See Figure 3.3. 

10.  To engage the blades, pull out and up on Blade Clutch 

Switch moving it to ON position.  See Figure 3.4. 

 
NOTE: Releasing the Operator’s Presence Control 
(OPC) while Transmission is in GEAR and/or Blades 
ON, will Ground the Ignition Circuit and cause the Engine 
to STOP, allowing the Machine to travel only a few feet 
before coming to a complete STOP.