Snapper ER195517B Benutzerhandbuch

 

1. FRONT WHEELS: Reposition the front axle by 
raising the front wheels off the ground, then pull in 
the spring loaded bushings until they clear the 
brackets. Move bushings to the desired height of 
cut position and release the bushings. See Figure 
2.6. 
 
2. REAR WHEELS: Reposition the rear axle by 
raising the rear wheels off the ground, then pull in 
the spring loaded bushings until they clear the 
brackets. Move bushings to the desired height of 
cut position and release the bushings. Position the 
rear bushings in to the same notches 
corresponding with notches for the front wheels to 
maintain the level of the deck. See Figure 2.6. 

 
NOTE: There are four cutting height adjustment notches 
on each wheel. The top notch is the lowest cutting height 
and the lowest notch is the highest. 
 

 

 

NOTE: For best recycling results, cut up to a maximum 
of 1/3 of grass blade length and recycle ONLY when 
grass is dry. 
 
 
 

1.  Set all wheels in the highest cutting position 
(Notch 4). 
2.  Proceed mowing slowly. If grass is very dense, 
lower each rear wheel latch one notch lower than 
the front wheel latches to improve recycling 
performance. 

 
2.7 RECYCLING 

1. REMOVAL: The recycling cover is secured in 
place with two knobs. To remove the cover, 
unscrew the two knobs and lift off the cover. See 
Figure 2.7.  
2. INSTALLATION: When reinstalling the cover, 
the deck sidewall should fit between the tab and 
outside of cover. Tighten knobs securely. See 
Figure 2.8. 

 

 

 

 

 
 
 
 
 
 
 
 
 
 
 

 

 

 

FIGURE 2.8