Snapper RP217019BVE Benutzerhandbuch

 

1. Make sure fuel valve on engine is open. See 
Figure 2.5. 

 

 

 

2.  Move engine speed control past “Fast” detent to 
“Choke” position. See Figure 2.4 and 
“FAMILIARIZATION”. 
3.  Pull blade control against handle. 
4.  Pull rope start handle to crank engine. 
5.  After engine starts, turn off choke, reduce engine 
speed, and allow a brief warm-up until engine runs 
smooth. 

NOTE:  Stop the engine (and blade) by releasing the 

blade control. 

 

1. Start engine. Refer to Section “Starting & 

Operation”. 

2.  Move ground speed control to the desired speed 

position. See Figure 2.6. 

3.  Move wheel drive control against handle to 

engage wheel drive and propel mower forward. 

Forward speed can be adjusted while the mower is 

moving by changing position of the ground speed 

control. See Figure 2.6. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 

Stop forward motion of mower by releasing the 

wheel drive control. Stop engine and blade by 
releasing the blade control. 

 

The height of the mower handle can be adjusted as 
follows: 
1.  Loosen the lower nuts on each lower handle as 
shown in Figure 2.7. 

 

 

2.  Move upper mower handle up or down until the 
desired position is achieved. 
3.  Tighten the lower nuts on each lower handle to 
maintain desired position. 

 

1.  Pull the height adjusting latch outward and move 
to desired cutting height. See Figure 2.8.