Woods Equipment CZR2242B Benutzerhandbuch

39

1.  Remove cutterdeck belt (see cutterdeck belt 

replacement).

2.  Disconnect wire I at clutch M.  Remove bolts J 

and remove torque restraint.

3.   Using a ratchet with a 9/16" socket, place over 

nut at location P.  Use the ratchet to rotate it 
enough to remove the transaxle drive belt.

4.   Install a new transaxle drive belt by performing 

these steps in reverse order.

5. 

Inspect  the  fans.    Replace  if  worn  or  damaged.                                                                                   
Torque transaxle pulley nut to 28.3-41.6 ft-lbs 
(38-56 Nm). 

6.  Reinstall cutterdeck belt (see cutterdeck belt 

replacement). 

NOTE:  Always use Woods replacement belts, not general purpose belts.  Woods belts 
are specially designed for use on this mower and will normally last longer.

1.  Remove floorplate.
2.   Set the cutterdeck in a middle height-of-cut posi-

tion.  

3.   Use a 3/8" ratchet and extension to back 

tensioning idler off to remove belt from idler.  
Remove belt from cutterdeck pulleys.

NOTE:  Use the 3/8" ratchet in the square hole A on 
the idler.

4.   Remove belt from clutch pulley. 

5.   Install the new belt by performing these steps in 

reverse order.

All belts are tensioned by spring loaded idlers and do 

not require any adjustment.