Troy-Bilt 830 Benutzerhandbuch

7.  Replace with new belt, working it between the deck 

and baffle, first around the transmission pulley and 
then the engine pulley.

NOTE:  Make certain that belt is seated correctly and 
that it is riding smoothly on the engine pulley and is not 
pinched between the lower and upper pulley halves.

8.  Tighten self-tapping screw securing deck baffle 

loosened earlier.

9.  Replace engine baffle and secure with self tapping 

screws.

10. Replace blade, blade adapter, and associated 

hardware. Follow instructions in Blade Care section 
for proper assembly.

11. Tip mower back onto its wheels and remove piece of 

plastic from under gas cap (if applicable). 

way. Do not put batteries in fire as these may burst 
or release toxic materials.
1.  Loosen round handle knobs securing upper and 

lower handles and carefully fold the upper handle 
down toward the lower handle as shown in Figure 
5-6.

2.  Remove the two screws securing battery cover to 

battery housing and place them to the side. See 
Figure 5-6.

3.  Open battery cover, remove positive and negative 

leads from battery, remove and replace with new 
battery. See Figure 5-7. Connect the positive lead to 
the positive side of the battery pack, then connect 
the negative side.

NOTE: The battery you have may differ slightly from the 
one shown in Figure 5-7. Refer to the Parts List.

4.  Reattach battery cover to battery housing by secur-

ing with the two screws removed earlier, making sure 
to snap the wire conduit on the left into place on the 
housing.

5.  Fold handles back up and tighten handle knobs.

Figure 5-6: Fold down upper handle and remove two screws 
from back of housing.

Figure 5-7: Open cover to view battery and wires.

NOTE: Make certain 
that belt is seated 
correctly and that it is 
riding smoothly on the 
engine pulley and is not 
pinched between the 
lower and upper pulley 
halves.