Troy-Bilt J830 Benutzerhandbuch

Remove back cover of speed control housing by removing 
the three screws securing it to the housing. See Fig. 6-4. 

Remove screw and flat washer securing cable. See Fig. 6-4.
NOTE: Make sure to take note of which slot in housing 
cable is in.

5.

6.

Using a pair of needle nose pliers or similar tool, move 
eyelet in cable only one slot to the left in housing as shown 
in Fig. 6-5.

NOTE: Moving eyelet to the left speeds unit up; moving it 
to the right slows it down.
Replace screw and washer removed earlier. Reassemble 
back of housing. Reattach battery harness assembly to the 
speed control housing, making sure to snap the tab on the 
harness into the slot on the housing. See Fig. 6-3. Secure 
with the three screws removed earlier.

7.

8.