Troy-Bilt LTX-1842 Benutzerhandbuch

Seite von 48
16
42-inch Decks
To operate the cutting deck without mulching, simply 
remove the mulch plug by unthreading the plastic wing 
nut which fastens it to the cutting deck. This will allow 
the clippings to discharge out the side. See Figure 6 .
46-inch Decks
The mulch kit is packed separately within the tractor’s 
crate. Observe the instructions included with the mulch 
kit for the best results when mulching.
Figure 6
SECTION 6:  MAKING ADJUSTMENTS
WARNING: 
Never attempt to make any
adjustments while the engine is running.
WARNING: 
Disconnect the spark plug
wire(s) and ground against the engine before
performing any adjustments, repairs or
maintenance.
Steering Adjustment
If the tractor turns tighter in one direction than the other, 
or if the ball joints are being replaced due to damage or 
wear, the steering drag links may need to be adjusted.
Adjust the drag links so that equal lengths are threaded 
into the ball joint on the left side and the ball joint on the 
right side:
Loosen the jam nut found on the drag link at the 
rear of the ball joint. See Figure 7.
Remove the hex nut and lock washer on the top of 
ball joint. See Figure 7.
Thread the ball joint toward the jam nut to shorten 
the drag link. Thread the ball joint away from the 
jam nut to lengthen the drag link.
Replace hex nut and lock washer and retighten the 
jam nut after proper adjustment is achieved.
NOTE: 
Threading the ball joints too far onto the drag
links will cause the front tires to "toe-in" too far. Proper
toe-in is between 1/16" and 5/16".
Front tire toe-in can be measured as follows:
Place the steering wheel in position for straight 
ahead travel.
Figure 7
In front of the axle, measure the distance 
horizontally from the inside of the left rim to the 
inside of the right rim. Note the distance.
Behind the axle, measure the distance horizontally 
from the inside of the left rim to the inside of the 
right rim. Note the distance.
The measurement taken in front of the axle should 
be between 1/16" and 5/16" less than the 
measurement taken behind the axle. Adjust if 
necessary.
Carriage Screw
Plastic Wing Nut
Bell
Washer
Mulch Plug
Drag Link
Ball Joint
Axle
Pivot Bar
Hex Nut and
Jam Nut
Lock Washer
(if equipped)