Troy-Bilt N779Pony Benutzerhandbuch

21

To remove the cutting deck, proceed as follows:
•

Place the PTO (Blade Engage) lever in the 
disengaged (OFF) position.

•

Engage the parking brake.

•

Lower the deck by moving the deck lift lever into the 
bottom notch on the right fender.

•

Remove the belt from around the tractor’s engine 
pulley and idler pulley(s). Refer to Changing the Deck 
Belt on page 24 for detailed instructions. See Figure 
20.

•

Looking at the cutting deck from the left side of the 
tractor, locate the hair pin clip that secures the deck 
support rod on the rear left side of the deck. See 
Figure 15.

•

Remove the hair pin clip that secures the deck 
support rod, and carefully remove the deck support 
from the deck lift arm.

•

Repeat the above steps on the tractor’s right side.

•

Move the deck lift lever into the top notch on the 
right fender to raise the deck lift arms up and out of 
the way.

•

Carefully remove the PTO cable from the rear of 
the cutting deck by removing the hair pin clip which 
secures it. Proceed to remove the spring from the 
deck idler bracket. See •.

•

Gently slide the cutting deck toward the front of the 
tractor allowing the hooks on the deck to release 
themselves from the deck stabilizer rod.

•

Gently slide the cutting deck (from the right side) 
out from underneath the tractor.

Never exceed the maximum

inflation pressure shown on the sidewall of the
tire.

The recommended operating tire pressure is:

•

Approximately 10 psi for the rear tires 

•

Approximately 14 psi for the front tires

 Refer to the tire sidewall for exact tire 

manufacturer’s recommended or maximum psi. Do not 
overinflate. Uneven tire pressure could cause the 
cutting deck to mow unevenly.

Hair Pin Clip

Hair Pin Clip

PTO Cable

Idler Bracket