Troy-Bilt 430 Series Benutzerhandbuch

7

•

Remove staples, break glue on top flaps or cut tape 
at carton end and peel top flap to open carton.

•

Remove loose parts if included with unit.

•

Cut corners and lay carton down flat. Remove 
packing material.

•

Roll or slide unit out of carton. Check carton 
thoroughly for loose parts.

NOTE: Make sure not to crimp cables while removing
the loose parts or the entire unit from the carton.

Please identify each piece 
of the hardware pack as 
shown here.

•

Pair of Pliers 

•

Funnel 

NOTE: Reference to right or left hand side of the mower
is observed from the operating position.

•

For shipping purposes, the grass bag was placed 
on top of the unit. Remove it from the unit and set it 
out of the way. See Figure 1 .

•

Raise the lower handle, as shown in Figure 1 , until 
it snaps into place.

•

Raise the upper handle as shown in Figure 1 . 

•

Tighten the two wing nuts which are already on the 
handle. See Figure 2 .

NOTE: Make sure to route the cables outside the lower
handle. Also do not crimp the cables while lifting the
handle up.

•

Remove the hairpin clips from the outer hole in the 
weld pins on the handle bracket assemblies. Using 
a pair of pliers, squeeze one leg of the lower handle 
against the handle bracket assemblies. Insert the 
hairpin clip into the inner hole on the weld pin. 
Repeat on other side. See Figure 3.

•

After you have moved the hairpin clip, install the 
carriage bolt, (carriage bolt must go to the inside of 
handle) included in the hardware pack, in the upper 
hole on the handle mounting bracket. Secure with 
one plastic wing nut, also included in the hardware 
pack. See Figure 3. Repeat process on other side.

Tighten these 
wing nuts

Move Hairpin Clip