Alamo PA92 Benutzerhandbuch
OPERATION
PA92 04/09
Operation Section 4-28
© 2009 Alamo Group Inc.
OPERA
T
ION
For Downward Cutting
For downward cutting, a rear hood kit Part No.
71-90-310 must be fitted. The front hood may be
removed to allow longer material to be cut. If this
is done, the rotor should never be reversed to cut
upwards even momentarily. It is stressed that the
rear flap fitted as standard is not suitable for
downward cutting.
71-90-310 must be fitted. The front hood may be
removed to allow longer material to be cut. If this
is done, the rotor should never be reversed to cut
upwards even momentarily. It is stressed that the
rear flap fitted as standard is not suitable for
downward cutting.
Do not remove the lever stop gate.
Reversing Rotation (Si Only)
Fully extend the armhead and lower flail to the ground to minimize oil loss. Release the rotor hoses from either
the flail motor or the rotor control valve and interchange the connections. Do not cross over the flail supply and
return hoses at any other point as the hose routing and cross overs in the installation are necessary to allow
the hoses to flex correctly during arm movements.
the flail motor or the rotor control valve and interchange the connections. Do not cross over the flail supply and
return hoses at any other point as the hose routing and cross overs in the installation are necessary to allow
the hoses to flex correctly during arm movements.
To ascertain the direction of cut without running the machine the following applies.
Connection MP - lower motor connection - upward cutting
Connection MR - upper motor connection - upward cutting
Connection MP - upper motor connection - downward cutting
Connection MR - lower motor connection - downward cutting