Alamo PA92 Benutzerhandbuch

PA92   04/09

Operation Section 4-31

© 2009 Alamo Group Inc.

Flails must cut upwards.

Front hood CW flaps, skids and rear flap must be
fitted.

The mounting holes allow two positions for the front
hood and two positions for the skids. Any
combination of these positions may be used.

The roller can be set in positions 2 and 3 for bushed
rollers or positions 2, 3 and 4 for ball bearing rollers.

The hydraulic float kit, if fitted, should be mounted as shown in the vertical position clamped to the lift ram
barrel.

In work, with the tap open, the flail head automatically follows the ground contours.

The lift control should be operated to take a proportion of the flail head weight off the flail roller. This is
important, too little weight on the roller will leave uncut areas of grass while with too much weight on the roller
the ground will be scalped in places and increased flail wear, loss or damaged to flails could occur.

To revert to hedge cutting or to use the flail without it, running along the ground the stop tap should be closed to
isolate the accumulator.