Alamo PA92 Benutzerhandbuch
ASSEMBLY
PA92 04/09
Assembly Section 3-11
© 2009 Alamo Group Inc.
ASSEMBL
Y
REMOVAL FROM TRACTOR
1. Select a firm level site for parking the machine.
2. Remove the parking feet, turn through 90 degrees and relocate in their housings.
3. Unscrew the lift ram tap and with the machine at approximately half reach in normal working position, i.e.
2. Remove the parking feet, turn through 90 degrees and relocate in their housings.
3. Unscrew the lift ram tap and with the machine at approximately half reach in normal working position, i.e.
not broken back. Operate the hydraulic services until the flail head roller is horizontal and level with the feet
of the main frame.
of the main frame.
4. Disengage tractor PTO and remove.
5. Disconnect stabilizers bars or loosen check chains as applicable.
6. Unbolt the control unit from the mounting pillar, remove from tractor cab and stow in a suitable location
5. Disconnect stabilizers bars or loosen check chains as applicable.
6. Unbolt the control unit from the mounting pillar, remove from tractor cab and stow in a suitable location
clear of the ground. On Si models only, the supply and return hoses must be disconnected from the tractor
and stowed with their ends covered and clear of the ground.
and stowed with their ends covered and clear of the ground.
7. Raise the machine on the tractor’s linkage to take the weight off the yoke and remove the lower yoke pins.
8. Lower the tractor draft links and place machine firmly on the ground.
9. Remove draft links and top link from the machine, drive tractor away and remove yoke. Blank off the end of
8. Lower the tractor draft links and place machine firmly on the ground.
9. Remove draft links and top link from the machine, drive tractor away and remove yoke. Blank off the end of
the return hose with plug or small plastic bag if a self-seal coupling is not fitted.