Alamo TX235 Benutzerhandbuch
MAINTENANCE
TX235 02/07
Maintenance Section 5-8
© 2007 Alamo Group Inc.
MAINTENANCE
BLADE SHARPENING
Always sharpen both blades at same time to maintain balance. Follow original sharpening pattern as shown in
Figure Mnt-R-0008 Always sharpen blades by grinding. DO NOT heat and pound out edge. Do not sharpen
blade to a razor edge, but leave a 1/16" blunt edge. Do not sharpen back side of blade. Mnt-R-0273.
Figure Mnt-R-0008 Always sharpen blades by grinding. DO NOT heat and pound out edge. Do not sharpen
blade to a razor edge, but leave a 1/16" blunt edge. Do not sharpen back side of blade. Mnt-R-0273.
Avoid personal injury. Always block the cutter up to prevent if from falling when the blades
and/or carrier are being serviced.
and/or carrier are being serviced.
When sharpening blades, grind each end the same amount to maintain balance.
Unbalanced blades will cause excessive vibration which can damage blade spindle
bearings. Vibration may also cause structural cracks in mower housing.
Unbalanced blades will cause excessive vibration which can damage blade spindle
bearings. Vibration may also cause structural cracks in mower housing.
BLADE INSTALLATION
Install washer on blade bolt, insert bolt into blade, thread bolt into spindle shaft.
NOTE: Blade bolt has left hand threads. Tighten blade bolt to 150 ft./lbs. Torque. Use heavy leather gloves
during tightening process to hold blade and wrench.
NOTE: Blade bolt has left hand threads. Tighten blade bolt to 150 ft./lbs. Torque. Use heavy leather gloves
during tightening process to hold blade and wrench.