Alamo RX96 Benutzerhandbuch
OPERATION
RX96 03/09
Operation Section 4-46
© 2009 Alamo Group Inc.
OPERA
T
ION
Gearbox Leaking
Damaged Oil Seal
Replace Seal.
Bent Shaft.
Replace Oil Seal and Shaft.
Oil Seal Race rough.
Replace Shaft or repair Race.
Oil Seal installed wrong.
Replace Seal.
Oil Seal not sealing in the housing.
Replace Seal or use a sealant on O.D.
of Seal.
Oil level too high.
Drain oil to proper level.
Gasket damaged.
Replace Gasket.
Bolts loose.
Tighten Bolts.
No Oil Seal
Install Oil Seal
Oil too light.
Use EP140.
Bearings loose.
Adjust Bearings.
Vent Plug stopped up.
Open Vent Plug.
No oil seal.
Install oil seal.
Oil too light.
Use EP140.
Oil level too high.
Drain oil to proper level.
Gasket damaged.
Replace gasket.
Bolts loose.
Tighten bolts.
Rapid Clevis Wear
Washers not used.
Install washers above & below drawbar
Clevis bending or spreading
Using pin or bolt not tightened.
Use 1” gr5 or 8 bolt & tighten nut.
open.
Tongue bending or binding
Improper Drawbar.
Add attaching Plate to all 3-Point
in turns.
drawbars.
Breaking Blade Bolts
Operating with loose Blade Bolts.
Tighten Blade Bolts to 300 ft./lbs
(Right Hand threads)
(Right Hand threads)
Worn Blade Bolt.
Replace Bolt.
Cutting Too High
Blades bent up.
Replace Blades.
Blade Carrier bent.
Straighten or replace Blade Carrier.
Blades on upside down.
Turn Blades right side up and tighten.
Mower Windrowing
Cutting heavy material.
Raise mower and reduce
ground speed.
ground speed.
Broken Cross or Cups
Load too high for joint.
Use protective device with joint.
Check joint angles and phasing.
Slow down or raise Mower.
(See Clutch Maintenance)
Check joint angles and phasing.
Slow down or raise Mower.
(See Clutch Maintenance)
End Galling of Cross
Speed too high during turns.
Reduce PTO speed.
and Cups