Alamo RX96 Benutzerhandbuch

RX96   03/09

Assembly Section 3-2

© 2009 Alamo Group Inc.

The RX96 Mower will attach to most tractors with Cat. II & III and II & III Quick Hitch. The RX96 can be
purchased for tractors with 540 or 1000 RPM PTO. 

Assembly of this mower is the responsibility of the Alamo Industrial dealer. The mower should be delivered to
the owner completely assembled, lubricated, and adjusted for normal cutting conditions.

Set up mower as received from the factory with these instructions. Open parts box and lay parts out to make
location easy. Refer to the parts lists and exploded view drawings for more detail.

This mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely
assembled before tightening hardware.

Always use personal protection devices such as eye, ear and feet protectors during
assembly.

1.

Insert bushing (15) into lower end of each A-Frame half (1 & 2). Position each A-Frame half inside
Mainframe Lug. Install bolt (19) with Flatwasher (20) through bushing (15) in A-Frame half (1 & 2) and hole
in inside Mainframe lug. Install locknut (10).

2.

Install bushing (6) between braces (3) through top rear hole of A-Frame and insert bolt (12), flatwasher
(20) and locknut (10). Install Driveline Holder Bracket (22) to left A-Frame (2) with bolt (17) and locknut
(18).

3.

Install bushing (21) between A-Frame halves (1 & 2) and insert bolt (13) and locknut (14). Then attach
braces (3) and brace (7) by installing bushings (15) through brace (7), and install bolt (9) and locknut (10)
through braces (3) and brace (7). Then attach another bushing (5) in between braces (3) with bolt (9), and
locknut (10).

4.

Install brace support (7) to the rear lugs on the Mainframe with pivot pin (8) and retain with bolt (17) and
locknut (10). FIGURE Asm-R-0282