Alamo RX96 Benutzerhandbuch

RX96   03/09

Assembly Section 3-9

© 2009 Alamo Group Inc.

Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To
ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a
shield. (Figure Asm-R-0129)

Attach the slip clutch end of the driveline to the gearbox input shaft securely. Make certain that the slip clutch is
fully onto the input shaft splines. Tighten the locknuts (2) alternately until they have reached the proper torque.
Refer to Torque Chart in Maintenance Section.)

Attach the Brackets (1& 2) to the Gearbox. Install
Shield  (3)  to  brackets  (1  &  2)  with  Bolt  (4)
Flatwashers (5) and locknut (8). Close Shield and
retain with Bolt (6), Flatwasher (5) and with Thumb
nut (7). (Figure Asm-R-0297) Proceed to attach
Divider Shield (1) with bolt (2) and Lockwasher (3).
Retain Divider Shield with Thumb Nut (4) and
Flatwasher (5). (Figure Asm-R-0298

SHIELD ASSEMBLY - Main Input - Lift and Pull

Attach the Bracket (1) to the Center Gearbox with
M10 x 35 Bolts (2), and Flatwasher (3). Install
Shield (5) and retain with 1/2” Wing Nut (4).