Alamo 260 Benutzerhandbuch
MAINTENANCE
260/272/284 01/11
Maintenance Section 5-9
©2011 Alamo Group
MAINTENANCE
MAIN CV DRIVELINE SAFETY SHIELD
1. To remove the outer CV cone, remove the locking screws from shield cone. Remove cone over yoke.
Remove bearing ring and remove the locking screws from inner shield cone. Turn inner cone to assembly
position and remove half shield. Remove bearing ring. MNT-R-0038.
position and remove half shield. Remove bearing ring. MNT-R-0038.
2. To assemble outer CV driveline, grease yoke groove and inner profile tube. Attach bearing ring on groove
with recesses facing profile tube. Slide on half shield with cone. Turn cone until it engages correctly.
Tighten locking screws. Grease bearing groove in double yoke. Insert bearing ring. Slide guard cone for
double yoke over cam from the connecting end. Make sure holes for screws are visible. Tighten locking
screws. MNT-R-0039.
Tighten locking screws. Grease bearing groove in double yoke. Insert bearing ring. Slide guard cone for
double yoke over cam from the connecting end. Make sure holes for screws are visible. Tighten locking
screws. MNT-R-0039.