Alamo Eagle 14 Benutzerhandbuch

Eagle 20   03/09

Operation Section 4-17

© 2009 Alamo Group Inc.

•

Disconnect driveline from the tractor and slide 
the profiles together until fully compressed. 

•

Place a mark  on the inner shield  1/8” from the 
end of the outer shield.

•

Reattach the driveline to the PTO Shaft.

•

Lift Type - With the PTO NOT TURNING, raise 
and lower the mower and watch shaft move-
ment.
Pull Type - With the PTO NOT TURNING, drive 
the tractor and mower through the sharpest turn 
possible and watch shaft movement.  With the 
PTO NOT TURNING, drive the tractor and 
mower through the most severe terrain condi-
tions expected and watch shaft movement.

•

Raise the mower and watch the driveline as it 
approaches the mark.  If the distance between the mark and the end of the outer shield tube becomes less 
than 2” at any point, contact your local dealer or tech service for proper directions.   OPS-R-0004_B

•

With the driveline attached, position the mower to the point where the telescoping driveline is at its maximum 
extension. Completely shut down the tractor and secure in position.

•

Mark the inner driveline shield 1/8” from the end of the outer shield.

•

Disconnect the driveline from the tractor and separate the two driveline halves. 

•

Measure the distance from the mark to the end of the inner profile. This length is the amount the driveline profiles were 
engaged.

•

If the engaged length is less than 6”, the shaft is considered too short and should be replaced with a longer shaft. 
Consult an authorized dealer to purchase the required driveline length.