Alamo EAGLE 10/15 Benutzerhandbuch

EAGLE 15   03/09

Maintenance Section 5-24

©2009 Alamo Group Inc.

Install the Bearing Race into the Hub cap.

Install the Bearing on the Output Shaft. FIGURE Mnt-R-0054. Place the Shaft into the Hub Cap. FIGURE Mnt-

R-0055. Place the Bearing (FIGURE Mnt-R-0056) on the Shaft and drive it down. Place the Gear (FIGURE

Mnt-R-0057) on the Shaft.

Apply some Locktite on the Adjusting Nut (FIGURE Mnt-R-0059).    Install the Adjusting Nut onto the Shaft.

Tighten the Nut until it is difficult to turn the Shaft. FIGURE Mnt-R-0060. Check to be sure that the Retaining

Ring is fully engaged in the counter bore. While holding Hub, tap each end of Shaft and check to see if it has