Alamo EAGLE 10/15 Benutzerhandbuch

EAGLE 15   02/08

Assembly Section 3-5

©2009 Alamo Group Inc.

Keep coworkers and bystanders away from the implement while filling.

13. Continue to hold the control lever until both wings are down and the wing cylinders are fully extended. Con-

tinue to cycle the cylinders several times by raising and lowering the wings fully to remove any trapped air.
If there is sponginess during the raising cycle, this may indicate that air is trapped in the hydraulic circuit.
Continue to cycle the cylinders until all sponginess is removed.

14. Test to make sure the wings lower slowly when they are allowed to float down and are not powered down.

This is a safety feature built into the system. If the wings fall rapidly, have the hydraulic system or cylinders
repaired before operating the implement.

 Many of the equipment components are HEAVY (60 lbs or greater) and Special Lifting

Procedures are recommended. Use lifting assistance such as mechanical assistance, two

people, and proper lifting techniques when connecting or installing the driveshaft to reduce

DO NOT use a PTO adapter to attach a non-matching Implement driveline to a Tractor

PTO.  Use of an adapter can double the operating speed of the Implement resulting in

excessive vibration, thrown objects, and blade and implement failure.  Adapter use will also

change the working length of the driveline exposing unshielded driveline areas.  Serious

bodily injury and/or equipment failure can result from  using a PTO adapter.  Consult an

authorized dealer for assistance if the Implement driveline does not match the Tractor PTO.

(S3PT-14)

When attaching  the  Implement  input  driveline  to  the  Tractor  PTO,  it  is  important  that  the

connecting yoke spring activated locking collar slides freely and the locking balls are seated

securely in the groove on the Tractor PTO shaft.  Push and pull the driveline back and forth

several times to ensure it is securely attached. A driveline not attached correctly to the

Tractor PTO shaft could come loose and result in personal injury and damage to the

Implement. 

 (S3PT-17)

The driveline yoke and tractor PTO shaft must be

dirt free and greased for attachment.

To connect the mower driveline to the tractor PTO

output shaft, pull the driveline yoke collar back and

align the grooves and splines of the yoke with those

of the PTO shaft.  Push the driveline yoke onto the

PTO shaft, release the locking collar, and position

the yoke until the locking collar balls are seated

onto the PTO shaft.  Push and pull the driveline

back and forth several times to ensure a secure

attachment.  OPS-R-0003_I