Ferris Industries 5900591 Benutzerhandbuch

www.ferrisindustries.com

 1.  Park the tractor on a smooth, level surface such 

as a concrete floor.  Disengage the PTO, engage 
the parking brake, turn off the engine, and remove 
the ignition key.

 2.  Remove the PTO drive belt from the clutch (see 

CLUTCH BELT REMOVAL for instructions).

 3.  Using a 1/2” breaker bar, place the square end in 

the square hole located in the middle of the idler 
arm  (A, Figures 48).  Carefully rotate the breaker 
bar COUNTER-CLOCKWISE, which will relieve 
the tension on the belts exerted from the idler 
arm.

 4.  Remove the belts from the right-hand and left-

hand pump drive pulley grooves.

 5.  Carefully release the tension on the breaker bar.

 6.  Unhook the spring (B) from the anchor bolt on the 

idler arm.

 7.  Remove the belts from the crankshaft pulley 

grooves and pull out from behind the clutch.

 1.  Place the belts under clutch into the crankshaft 

pulley grooves.

 2.  Wrap the belts around the top side of the idler arm 

pulley and install the belts in the right-hand pump 
pulley grooves.

 3.  Reinstall the spring onto the anchor bolt on the 

idler arm.

 4.  Carefully rotate the idler arm with the breaker bar 

COUNTER-CLOCKWISE (see Figure 48).  While 
holding the breaker bar firmly, install the belts in 
the left-hand pump pulley grooves and the two 
stationary idler pulleys grooves.

 5.  Carefully release the tension on the breaker bar.

 6.  Inspect the belt path making sure that all belts are 

properly seated in the pulley grooves.

 7.  Reinstall the clutch belts (see CLUTCH BELT 

REPLACEMENT for instructions).

Troubleshooting, Adjustment & Repair

Not 

for  

Reproduction