Jonsered LT2220 CMA2 Benutzerhandbuch

Should your transmission require removal for service or 

replacement, it should be purged after reinstallation and 

before operating the tractor.  See “PURGE TRANS MIS SION” 

in the Operation section of this manual.

• Raise 

hood.

•  Unsnap headlight wire connector.
• 

Stand in front of tractor.  Grasp hood at sides, tilt toward 

engine and lift off of tractor.

•  To replace, reverse above procedure.

The throttle control has been preset at the factory and 

ad just ment should not be necessary.  If adjustment is 

necessary, see engine manual.

The choke control has been preset at the factor and adjust-

ment should not be necessary.  If adjustment is necessary, 

see engine manual.

The carburetor has been preset at the factory and ad just ment 

should not be necessary.  However, minor ad just ment may be 

required to compensate for differences in fuel, temperature, 

altitude or load.  If the carburetor does need adjustment, 

see engine manual.

02141

• Raise 

hood.

•  Pull bulb holder out of the hole in the backside of the 

grill.

•  Replace bulb in holder and push bulb holder securely 

back into the hole in the backside of the grill.

• Close 

hood.

Loose or damaged wiring may cause your tractor to run 

poorly, stop running, or prevent it from starting.
•  Check wiring.  

Replace with 20 amp automotive-type plug-in fuse.  The 

fuse holder is located behind the dash.

•  Open battery cover.
• 

Disconnect BLACK battery cable first then RED battery 

cable and carefully remove battery from tractor.

•  Install new battery with terminals in same position as 

old battery.

• 

First connect RED battery cable to positive (+) terminal 

with bolt and nut as shown. Tighten securely. Slide 

terminal cover over terminal.

• 

Connect BLACK grounding cable to negative (-) ter mi nal 

with remaining bolt and nut. Tighten se cure ly.

•  Close battery cover.