Jonsered LT2220 CMA2 Benutzerhandbuch

Adjust seat before tightening adjustment knob.
•  Remove adjustment knob and flat washer securing 

seat to cardboard packing and set aside for assembly 

of seat to tractor.

• 

Pivot seat upward and remove from the cardboard pack-

ing. Remove the cardboard packing and discard.

•   Place seat on seat pan so head of shoulder bolt is 

positioned over large slotted hole in pan.

•   Push down on seat to engage shoulder bolt in slot and 

pull seat towards rear of tractor.

•   Pivot seat and pan forward and assemble adjustment 

knob and flat washer loosely. Do not tighten.

•  Lower seat into operating position and sit on seat.
•  Slide seat until a comfortable position is reached 

which allows you to press clutch/brake pedal all the 

way down.

•  Get off seat without moving its ad just ed position.
•  Raise seat and tighten adjustment knob securely.

02

46

6

02464

• 

Remove discharge chute from rear of tractor.  Unhook  

the two (2) straps and pull chute out and away from 

tractor.

• 

Remove the two (2) 3/8 nuts and flat washers from the 

bolts at the tractor back plate.

NOTE: You may now roll your tractor off the skid. Follow the 

instructions below to remove the tractor from the skid.

  WARNING: Before start ing, read, un der stand and fol low 

all in struc tions in the Op er a tion section of this man u al. Be 

sure tractor is in a well-ventilated area. Be sure the area in  

front of tractor is clear of other peo ple and objects.

•  Raise attachment lift lever to its highest po si tion.
• 

Release parking brake by de press ing clutch/brake ped al.

•  Place freewheel control in "trans mis sion dis en gaged" 

position (See “TO TRANS PORT” in the Op er a tion 

section of this manual).

•  Roll tractor forward off skid.
• 

Remove banding holding the deflector shield up against 

tractor.

Continue with the instructions that follow.

•  Using the nuts and flat washers removed from tractor 

back plate, install the bagger support tube to the back 

plate as shown. Tighten securely.

• 

Install the two upper support brack ets through the back 

plate and to the  chas sis, install the clevis pin 10x17mm 

and secure with retainer spring.

•  Assemble both support brackets to the outside of the 

bagger support tube using two each 3/8 x 63,5mm 

hex bolts13/32" I.D. flat washers and 3/8 locknuts from 

parts bag. Tight en securely.

•  Replace discharge chute into rear opening of tractor.  

Secure the chute with the two hook straps.

02330

02590

02

277