Husqvarna WHF3617 Benutzerhandbuch
lUBRICATIoN
Husqvarna-39
Engine Oil
5.
The engine oil should be changed for the first time
after 8 hours of operation. Thereafter, it should be
changed every 100 hours.
Place the machine on a flat surface.
Place the machine on a flat surface.
Place a container under the engine where
•
the oil drain valve exits.
Remove the dipstick and open the valve cap.
Remove the dipstick and open the valve cap.
•
Allow the oil to run out into the container.
•
Close the oil drain valve cap.
•
Replace the oil filter if necessary.
•
Fill with new engine oil in accordance with
•
Checking the oil level.
Start the engine. Run it for 3-5 minutes. Stop
Start the engine. Run it for 3-5 minutes. Stop
•
and recheck the oil level.
Engine Oil Filter
4.
Drain the engine oil in accordance with the
•
work description under the heading Engine
oil/Change Engine oil.
Remove the oil filter. If necessary, use a filter
Remove the oil filter. If necessary, use a filter
•
remover.
Wipe new, clean engine oil onto the seal for
Wipe new, clean engine oil onto the seal for
•
the new filter.
Mount the filter by hand with +¾ turn.
Mount the filter by hand with +¾ turn.
•
Add replacement oil.
•
Run the engine warm, then check that there
•
are no leaks around the oil filter seal.
Check the oil level in the engine, fill
Check the oil level in the engine, fill
•
if necessary. The oil filter holds 0.1 qt
(0.1 liters) of oil.
IMPORTANT INFORMATION
Used engine oil is a health hazard and must
not be disposed of on the ground or in nature;
it should always be disposed of at a workshop
or appropriate disposal location.
Avoid skin contact; wash with soap and water
in case of spills.
8062-020
Oil drain valve
8062-015
Changing the oil filter
WARNING!
Engine oil can be very hot if it is
drained directly after stopping the
engine. Allow the engine to cool to a
safe temperature first.