Husqvarna WHF5223 / 966947006 Benutzerhandbuch
lUBRICATIoN
Husqvarna-39
Engine Oil
5.
The engine oil should be changed for the first time
after 8 hours of operation. Thereafter, it should be
changed every 100 hours.
Place the machine on a flat surface.
Place the machine on a flat surface.
Place a container under the engine where
•
the oil drain valve exits.
Remove the dipstick and open the valve cap.
Remove the dipstick and open the valve cap.
•
Allow the oil to run out into the container.
•
Close the oil drain valve cap.
•
Replace the oil filter if necessary.
•
Fill with new engine oil in accordance with
•
Checking the oil level.
Start the engine. Run it for 3-5 minutes. Stop
Start the engine. Run it for 3-5 minutes. Stop
•
and recheck the oil level.
Engine Oil Filter
4.
Drain the engine oil in accordance with the
•
work description under the heading Engine
oil/Change Engine oil.
Remove the oil filter. If necessary, use a filter
Remove the oil filter. If necessary, use a filter
•
remover.
Wipe new, clean engine oil onto the seal for
Wipe new, clean engine oil onto the seal for
•
the new filter.
Mount the filter by hand with +¾ turn.
Mount the filter by hand with +¾ turn.
•
Add replacement oil.
•
Run the engine warm, then check that there
•
are no leaks around the oil filter seal.
Check the oil level in the engine, fill
Check the oil level in the engine, fill
•
if necessary. The oil filter holds 0.1 qt
(0.1 liters) of oil.
IMPORTANT INFORMATION
Used engine oil is a health hazard and must
not be disposed of on the ground or in nature;
it should always be disposed of at a workshop
or appropriate disposal location.
Avoid skin contact; wash with soap and water
in case of spills.
WARNING!
Engine oil can be very hot if it is
drained directly after stopping the
engine. Allow the engine to cool to a
safe temperature first.
8062-032
Oil drain valve
8062-031
Changing the oil filter