Husqvarna YTH1342XP Benutzerhandbuch

•      Lift hood to raised position.
•      If this battery is put into service after month and year 

indicated on label (label located between terminals) 
charge battery for minimum of one hour at 6-10 amps. 
(See "BATTERY" in Maintenance  section of this manual 
for charging in struc tions).

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely.  Use 
the correct tools as necessary to insure proper tightness.

A socket wrench set will make assembly easier.  Stan dard 
wrench sizes are listed.

(2)  7/16" wrenches 

Utility knife

(1)  3/4" wrenches 

Tire pressure gauge

Pliers  

 

When right or left hand is mentioned in this man ual, it 
means when you are in the operating po si tion (seated 
be hind the steer ing wheel).

•      Remove all accessible loose parts and parts cartons  

from carton .

•      Cut, from top to bottom, along lines on all four corners 

of carton, and lay panels fl at.

•     Check for any additional loose parts or cartons and 

remove.

ASSEMBLE EXTENSION SHAFT AND BOOT
•      Slide extension shaft onto lower steering shaft.  Align 

mount ing holes in extension and lower shafts and install 
1/4 hex bolt and lock nut.  Tighten securely.

IMPORTANT: TIGHTEN BOLT AND NUT SECURELY TO 10-12 
FT. LBS TORQUE.

•      Place tabs of steering boot over tab slots in dash and 

push down to secure.

INSTALL STEERING WHEEL
•         Position front wheels of the tractor so they are pointing 

straight forward.

•      Remove steering wheel adapter from steering wheel 

and slide adapter onto steer ing shaft ex ten sion.

•     Position steering wheel so cross bars are hor i zon tal 

(left to right) and slide inside boot and onto adapt er.

•     Assemble large fl at washer, 1/2 hex nut and tighten 

se cure ly.

•     Snap steering wheel insert into center of steer 

ing 

wheel.

•     Remove protective materials from tractor hood and 

grill.

IMPORTANT:  CHECK FOR AND RE MOVE ANY STA PLES 
IN SKID THAT MAY PUNC TURE TIRES WHERE TRACTOR
IS TO ROLL OFF SKID.