Husqvarna 260 ACX Benutzerhandbuch

66 - English

A number of fault messages are listed below that can be shown on Husqvarna Automower

®

. If the same 

fault occurs frequently: contact your dealer.

Grass or other object has wrapped 
around the drive wheel.

Check the drive wheel and remove 
the grass or other object.

Grass or other object has wrapped 
around the drive wheel.

Check the drive wheel and remove 
the grass or other object.

Grass or other object has wrapped 
around the blade disc. 

Check the blade disc and remove the 
grass or other object.

The transformer is not connected to 
the mains supply or its miniature 
circuit-breaker has tripped.

Check the wall socket connection and 
whether the miniature circuit-breaker 
has tripped.

Reset the miniature circuit-breaker by 
removing the transformer’s power 
cord from the wall socket, wait 
10 seconds and then reconnect the 
power cord in the wall socket again.

Boundary wire broken.

Check the signal given by the LED on 
the charging station. If it flashes the 
loop is damaged. Repair the broken 
cable using an original waterproof 
coupler.

The connection between Automower

®

 

and the charging station has been 
lost. 

Place Automower

®

 in the charging 

station and change the PIN-code via 
Settings - Security - PIN code 
(shortcut 4-1-1). You can use the 
same PIN code as earlier.

This may be due to the boundary wire 
being routed in the wrong direction 
around an ”island”, which blanks out 
the signal.

Check that the boundary wire has 
been routed correctly.

If this occurs in isolated areas it may 
be due to interference from metallic 
objects (perimeter fence, 
reinforcement bar) or buried cables in 
the vicinity. 

Try moving the boundary wire.

Automower

®

 has got caught in 

something.

Free Automower

®

 and rectify the 

reason for it getting trapped.