Husqvarna PR 17 AWD Benutzerhandbuch

36 – 

English

Check the cutting unit’s parallelism as follows:

1

Check the air pressure in the tyres 60 kPa/0.6 bar/8.5 PSI.

2

Place the machine on a flat surface.

3

Put the lifting lever in the mowing position.

4

Measure the distance between the ground and the front 
and rear edges of the cutting unit hood. The cutting unit 
should have a slight slant, with the rear edge 2-4 mm (1/
8”) higher than the front edge.

1

Remove the front hood and right-hand fender.

2

Undo the nuts on the lift strut.

3

Screw out (extend) the stay to raise the rear edge of the 
cover.

Screw in (shorten) the stay to lower the rear edge of the 
cover.

4

Tighten the nuts after adjustment.

5

On completion of the adjustment the unit’s parallelism 
should be re-checked.

6

Fit the right-hand fender and the front hood.

On these cutting units with collision-proof blades, the blades 
are driven by one V-belt. Do as follows to change the V-belt:

1

Remove the cutting unit.

2

Open the lock for the track rod bolt.

Remove the bolt so the track rod is released in one end. 

3

Unscrew the bolt holding the unit frame bracket.

4

Remove the lock and pass the unit frame out.

5

Remove the two bolts on the unit frame.