Dixon RAM MAG 50 / 968999651 Benutzerhandbuch

English-

58

1.

Drain the engine oil in accordance with 
the work description under the heading 
Engine Oil/Change Engine Oil. 

2.

Remove the oil filter. If necessary, use a 
filter remover.

3.

Wipe new, clean engine oil onto the seal 
for the new filter.

4.

Mount the filter by hand with + 3/4 turn.

5.

Run the engine warm, then check that 
there are no leaks around the oil filter 
seal.

6.

Check the oil level in the engine, fill 
if necessary. The oil filter holds 
0.1 qt (0.1 liters) of oil.

This transaxle is designed with an external 
filter for ease of maintenance. To ensure 
constant fluid quality levels and longer life an 
oil filter change interval of every 200 hours is 
recommended.

The following procedure can be performed 
with the transaxles installed in the vehicle, 
and the vehicle on level ground. Apply the 
bypass valve for each transaxle and lock the 
vehicle parking brake.

1.

Remove the three 1/4” filter guard 
screws and filter guard. Clean any loose 
debris from around the perimeter of the 
filter. See illustrations.

2.

Place an oil drain pan (12” or more 
diameter and 8 qt. capacity is optimal) 
beneath the oil filter. Remove the oil filter 
from the transaxle.

3.

After the oil has drained, wipe the filter 
base surface off and apply a film of new 
oil to the gasket of the new replacement 
filter.

4.

Install the new filter by hand, turn 3/4 to 
one full turn after the filter gasket 
contacts the filter base surface.

5.

Re-install the filter guard with the three 
1/4” screws. Torque screws to 65 in/lbs. 
each.

6.

Repeat steps on the opposite side of 
transaxle drive.

8011-734

8019-011

1. Filter (guard removed)