Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Dixon
  4. 965882101
  5. Benutzerhandbuch

Dixon 965882101 Benutzerhandbuch

Download
Seite von 75
36-
DIXON
MAINTENANCE
Battery
Your mower is equipped with a maintenance free 
battery and does not need servicing. However, 
periodic charging of the battery with an automotive 
type battery charger will extend its life.
Keep battery and terminals clean.
• 
Keep battery bolts tight.
• 
See charge for charging times.
• 
Cleaning battery and terminals
Corrosion and dirt on the battery and terminals can 
cause the battery to “leak” power.
Lift seat and rotate forward.
1. 
Disconnect BLACK battery cable first, then 
2. 
the RED battery cable and remove the battery 
from the machine.
Rinse the battery with plain water and dry.
3. 
Clean terminals and battery cable ends with 
4. 
wire brush until shiny.
Coat terminals with grease or petroleum jelly
5. 
Reinstall battery.
6. 
Replacing battery
Lift seat and rotate forward.
1. 
Using two ½” wrenches disconnect BLACK 
2. 
battery cable then RED battery cable.
Position deck to lowest setting.
3. 
Front underside of frame, remove the nuts that 
4. 
secure the battery hold-down.
Carefully remove the battery from the mower.
5. 
Install new battery with terminals in the  same 
6. 
position as the old battery.
Reinstall battery hold-down and secure with 
7. 
nuts removed in Step 5.
First connect RED battery cable to positive (+) 
8. 
battery terminal with hex bolt and hex nut.
Connect BLACK grounding cable to negative 
9. 
(-) battery terminal with remaining bolt and nut
Tighten securely.
10. 
Lower seat
11. 
IMPORTANT INFORMATION
Do not attempt to open or remove caps 
or covers. Adding or checking level of 
electrolyte is not necessary.
Always use two wrenches for the terminal 
screws.
Always use protective glasses 
when handling the battery.
WARNING!
Do not short battery terminals by 
allowing a wrench or any other object 
to contact both terminals at the same 
time. Before connecting battery, 
remove metal bracelets, wristwatch 
bands, rings, etc.
Positive terminal must be connected 
first to prevent sparks from accidental 
grounding.
STANDARD 
BATTERY
STATE
OF 
CHARGE
APPROXIMATE BATTERY CHARGING TIME* 
TO FULL CHARGE AT 80
O
F / 27
O
C
Maximum Rate at:
50 Amps
30 Amps
20 Amps
10 Amps
12.6V
100%
 - FULL CHARGE -
12.4V
75%
20 min.
35 min.
48 min.
90 min.
12.2V
50%
45 min.
75 min.
95 min.
180 min.
12.0V
25%
65 min.
115 min.
145 min.
280 min.
11.8V
0%
85 min.
150 min.
195 min.
370 min.
*Charging time depends on battery capacity,  
condition, age, temperature and efficiency of charger
8050-109
Remove battery hold-down to replace battery