Dixon 965882001 Benutzerhandbuch

DIXON

-49

MAINTENANCE

Anti-scalp rollers
Anti-scalp rollers are properly adjusted when they

are just slightly off of the ground when the deck is at

the desired cutting height in the operating position.

Anti-scalp rollers then keep the deck in the proper

position to help prevent scalping in most terrain

conditions.

IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower on a

flat level surface.

The

anti-scalp rollers can be set in three positions:

Upper position 1½ to 2½" (38 to 64 mm) grass

•

Middle position 2½" to 4" (64 to 102 mm) grass

•

Lower position 4" to 6" (102 to 128 mm) grass.

•
The rollers should be approximately ¼" (6.5 mm) from

ground. Do not adjust the rollers to support the deck.

IMPORTANT INFORMATION
The anti-scalp rollers must not be used for

gauge wheels or the roller and deck may be

damaged.

8050-830

Anti-scalp rollers

IMPORTANT INFORMATION
DO NOT add any type of tire liner or foam fill

material to the tires. Excessive loads created

by foam filled tires will cause premature

failures.
Only use O.E.M. specified tires.

8011-619-4

1. Caster yoke
2. Caster bolt
3. Caster long spacer
4. Caster small spacers
Caster wheels

Caster Wheels

Check every 200 hours. Check that wheels rotates

freely. If wheels do not rotate freely take the unit to

your dealer for service.
Foam filled tires or solid tires will void the warranty.

Removal and installation of caster wheel
Remove nut and caster bolt.
Pull the wheel out of the yoke and take care of the

spacers.
Install in reverse order. Tighten caster bolt.

Hardware

Check daily. Inspect the entire machine for loose or

missing hardware.