Dixon SE 6125 KOH BF Benutzerhandbuch

MAINTENANCE

Dixon-

45

Leveling deck
Adjust the deck while the mower is on a level 

surface. Make sure the tires are inflated to the correct 

pressure. See “Technical Data” under Transmission. 

If tires are under or over inflated, you cannot properly 

adjust your deck.
Four slots control the height and pitch of the mower 

deck. The deck should be adjusted slightly higher in 

the rear.
NOTE:To insure accuracy of leveling procedure, 

mower deck drive belt must be installed prior to 

leveling deck.

Wear heavy gloves. Turn each outer blade 

1. 

tip to align with the deck or in a side-to-side 

manner.
Measure from the floor surface up to the 

2. 

bottom of the blade tip on the discharge side 

of the mower deck. Retain this measurement. 

Move to the opposite side, check that 

measurement is the same. If adjustment 

is required, loosen the locknut and move 

mounting bolt up or down in slot until both 

side-to-side measurements are equal. Retain 

measurement.
Turn both outer blades to align with the deck in 

3. 

front-to-rear manner. Reposition rear mounting 

bolts up or down until rear of mower deck is 

positioned level to 

1

/

8

" higher in the rear than 

the side-to-side measurement.
Confirm measurements once again. Blade tips 

4. 

should be level in a side-to-side manner. In the 

rear, blade tips should be level to 

1

/

8

" higher 

than side-to-side measurement. In the front, 

blade tips should be level to 

1

/

8

" lower than 

side-to-side measurement.

NOTE: This will place the mower deck in a base 

measurement position. Additional adjustment may be 

required to achieve desired cut for the type of grass or 

conditions being mowed.

8050-829

1. lift arm
2. Mounting bolts
Leveling the mower deck

1

2

2