Dixon 7234FX Benutzerhandbuch

1

/

8

"-¼" gap with park  

brake engaged

maINTeNaNCe

43

Neutral adjustments are made with the rear wheels off 
the ground and able to rotate, which is done with the 
engine running. 

Using a jack stand, raise the rear of the mower 

1. 

up off the ground enough so the tires can 
rotate freely. Make sure the machine is securely 
supported. 
Lift the seat and rotate fully forward until 

2. 

supported by the seat rod.
Unplug the safety switch and harness from the 

3. 

seat.
Using two 

4. 

9

/

16

" wrenches, loosen the jam nut 

next to the turnbuckle. (See illustration.)
Hold down the safety switch plunger and start 

5. 

the engine. Continue to hold the plunger down 
during the next two steps.
Keeping the drive levers in the neutral lock 

6. 

position, release the parking brake. The drive 
wheels should NoT rotate.
If the drive wheels rotate, turn the turnbuckle 

7. 

until the wheels stop. Release plunger to stop 
the engine.
Retighten the jam nut against the turnbuckle 

8. 

while holding the turnbuckle.
Duplicate procedure for the opposite wheel.

9. 

After adjustments are made, secure the safety 

10. 

switch and lower the seat.

8065-049

1. Jam Nut
2. Turnbuckle
Neutral adjustment

8065-050

Engage the park brake. Measure the distance 

6. 

between the D brake bolt and the brake swivel. 
The distance should be 

1

/

8

"-¼".

If adjustments are needed, loosen C jam nut. 

7. 

Turn the brake bolt until the distance is correct. 
Retighten C jam nuts.

8065-049