Dixon 435068 Benutzerhandbuch

Seite von 30
25
TO REPLACE HEADLIGHT BULB
• Raise 
hood.
•  Pull bulb holder out of the hole in the backside of the 
grill.
•  Replace bulb in holder and push bulb holder securely 
back into the hole in the backside of the grill.
• Close 
hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run 
poorly, stop running, or prevent it from starting.
• Check 
wiring.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-in fuse.  The 
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY 
(See Fig. 44)
• Raise 
hood.
•  Unsnap headlight wire connector.
• 
Stand in front of tractor.  Grasp hood at sides, tilt toward 
engine and lift off of tractor.
•  To replace, reverse above procedure.
ENGINE
TO AD JUST THROTTLE CON TROL CABLE 
The throttle control has been preset at the factory and 
ad just ment should not be necessary. If adjustment is nec-
 es sary, see engine manual.
TO AD JUST CHOKE CON TROL 
The choke control has been preset at the factory and ad-
 just ment should not be necessary. If adjustment is neces-
sary, see engne manual.
TO ADJUST CARBURETOR  
Your carburetor is not adjustable. If your engine does not 
operate properly due to suspected carburetor problems, 
take your tractor to an authorized service center for repair 
and/or adjustment.
Fig. 44
TRANSMISSION 
REMOVAL/RE PLACE MENT
Should your transmission require removal for service or 
re place ment, it should be purged after reinstallation and 
before operating the tractor.  See “PURGE TRANS MIS SION” 
in the Operation section of this manual.
SERVICE AND ADJUSTMENTS
02491
HEADLIGHT
WIRE
CONNECTOR
HOOD