Dixon 965882301 Benutzerhandbuch

54-

DIXON

LUBRICATION

8009-159

Changing the Engine Oil
The engine oil should be changed for the first time 

after 5-8 hours of operation. Thereafter, it should be 

changed every 50 hours. The oil drain valve is located 

on the left side of the unit, below the oil filter.

Place the machine on a flat surface.

• 

Place a container under the engine where the oil 

• 

drain valve exits.
Remove the valve cap. 

• 

Allow the oil to run out into the container.

• 

Reinstall the oil drain valve cap.

• 

Replace the oil filter if necessary.

• 

Fill with new engine oil in accordance with 

• 

Checking the Oil Level. 
Start the engine. Run it for 3-5 minutes. Stop and 

• 

recheck the oil level.

If possible, grease both ends of the cables and move 

the controls to end stop positions when lubricating. 

Refit the rubber covers on the cables after lubrication. 

Cables with sheaths will bind if they are not lubricated 

regularly. If a cable binds, it can disrupt operation.
If a cable binds, remove the cable and hang it 

vertically. Lubricate it with light engine oil until the oil 

begins to escape from the bottom. 
Tip: Fill a small plastic bag with oil and tape it so that 

it seals against the sheath and allow the cable to hang 

vertically from the bag overnight. If you do not succeed 

in lubricating the cable, it must be replaced.