Dixon 966496201 Benutzerhandbuch
OpERATION
28
WARNING!
Lead-acid batteries generate
explosive gases. Keep sparks,
flame and smoking materials
away from batteries. Always
wear eye protection when around
batteries.
explosive gases. Keep sparks,
flame and smoking materials
away from batteries. Always
wear eye protection when around
batteries.
Weak Battery
If your battery is too weak to start the engine, it should
be recharged. (See Battery in the Maintenance
be recharged. (See Battery in the Maintenance
section.)
If “jumper cables” are used for emergency starting,
follow this procedure:
If “jumper cables” are used for emergency starting,
follow this procedure:
Jumper Cables
Connect each end of the RED cable to the
1.
POSITIVE (+) terminal on each battery, taking
care not to short against chassis.
Connect one end of the BLACK cable to the
care not to short against chassis.
Connect one end of the BLACK cable to the
2.
NEGATIVE (-) terminal of the fully charged
battery.
Connect the other end of the BLACK cable
battery.
Connect the other end of the BLACK cable
3.
to a good CHASSIS GROUND on the mower
with the discharged battery, away from the fuel
tank and battery.
with the discharged battery, away from the fuel
tank and battery.
To remove cables, reverse order
Remove BLACK cable first from chassis and
1.
then from the fully charged battery.
Remove RED cable last from both batteries.
Remove RED cable last from both batteries.
2.
IMPORTANT INFORMATION
Your mower is equipped with a 12-volt
negative grounded system. The other vehicle
must also be a 12-volt negative grounded
system. Do not use your mower to start other
vehicles.
negative grounded system. The other vehicle
must also be a 12-volt negative grounded
system. Do not use your mower to start other
vehicles.
8011-642
Jumper cable connection