Dixon Black Bear Benutzerhandbuch

•Located to the right and front of the operator.
•Controls the cutting height.
•17 positions of adjustment
•Depress trigger and move lever

forward to lower deck.

•Pull lever back to raise deck.
•Set desired cut height with pin.
•Use  foot  pedal  to  assist  with

raising and lowering deck.

Note:  Always use high position

for transport.

The two holes at the front of the quadrant are for 1-1/2” and 1-3/4”

cut heights.

The four holes along the bottom of the quadrant are for one inch

cut height increments (2” to 5”).

The second row of holes from the bottom are for an additional 1/4”

of cut height over its mating one inch increment (2-1/4” to 5-1/4”).

The third row of holes from the bottom are for an additional 1/2” of

cut height over its mating one inch increment (2-1/2” to 5-1/2”).

The remaining three holes are for an additional 3/4” of cut height

over their mating one inch increments (2-3/4” to 4-3/4”).