Dixon D22H46 Benutzerhandbuch

•  Remove all accessible loose parts and parts cartons  

from carton .

•  Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels flat.

•  Remove mower and packing materials.
•  Check for any additional loose parts or cartons and 

remove.

•  Lift hood to raised position.
NOTE: If this battery is put into service after month and 

year indicated on label (label is located between terminals) 

charge battery for minimum of one hour at 6-10 amps. 

(See "BATTERY" in Maintenance  section of this manual 

for charging instructions).
•  For battery and battery cable installation see "RE-

PLACING BATTERY" in the "Service and Adjustments" 

section in this manual.

•  Sit in seat.
• 

Lift up adjustment lever (A) and slide seat until a com-

fortable position is reached which allows you to press 

clutch/brake pedal all the way down.

•  Release lever to lock seat in position.

NOTE: You may now roll your tractor off the skid. Follow the 

instructions below to remove the tractor from the skid.

  WARNING: Before start ing, read, un der stand and fol low 

all in struc tions in the Op er a tion section of this man u al. Be 

sure tractor is in a well-ventilated area. Be sure the area in  

front of tractor is clear of other peo ple and objects.

•  Raise attachment lift lever to its highest po si tion.
•  Release parking brake by de press ing clutch/brake 

ped al.

•  Place freewheel control in "trans mis sion dis en gaged" 

position (See “TO TRANS PORT” in the Op er a tion 

section of this manual).

•  Roll tractor forward off skid.
Continue with the instructions that follow.

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  

A socket wrench set will make assembly easier.  Stan dard 

wrench sizes are listed.
(1)  1/2" wrench 

Tire pressure gauge

(2)  7/16" wrenches 

Utility knife

  

Pliers

When right or left hand is mentioned in this man ual, it means 

when you are in the operating po si tion (seated be hind the 

steer ing wheel).

The tires on your tractor were overinflated at the factory 

for shipping purposes.  Correct tire pressure is important 

for best cutting performance.
•  Reduce tire pressure to PSI shown on tires.

For best cutting results, mower housing should be properly 

leveled.  See “TO LEVEL MOWER HOUSING” in the Service 

and Adjustments section of this manual.

See the figures that are shown for replacing motion and 

mower blade drive belts in the Service and Adjustments 

sec tion of this manual.  Verify that the belts are routed 

cor rect ly.

After you learn how to operate your tractor, check to see that 

the brake is operating properly.  See “TO CHECK BRAKE” 

in the Service and Adjustments section of this manual.